BELOW-GRADE WATERPROOFING – NEGATIVE SIDE

Application
Mix equal parts of Conpro Stop and Portland cement by hand,
(wear a rubber glove and mix in a small plastic container).
Continue mixing while the material changes from
a soupy liquid to a loose mortar (about 15 - 20 seconds).
Make a ball of material and force it into the leak.
Hold in place for 20 - 30 seconds.
This will become easy with practice. Add sand or change
the ratio of cement to Conpro Stop to adjust set time.
The plug must be top coated with Conpro Seal.
Spray Conpro Stop on to weeping area and immediately
rub in cement with gloved hand. Repeat procedure until
the weeping water has stopped. In severe conditions
it may be necessary to relieve pressure by drilling
weep holes below the weeping area.